| |
| 1、RADAR RCB 6.8 CHARGER |
 |
USER MANUAL |
1 、 Characteristic:
• The charger must be kept apart, in order to guarantee personal safety.
• self-adjusting fuse installed, short circuit and reverse protect ,
• Charged current is shown in ladder, which not only shows charged electric current ,but also show the quantity of charge. |
| 2 、 echnical standard |
Item type
|
Input voltage |
Output voltage |
Charged electric current |
Storage battery charger |
RCB-6 |
50HZ 220V |
12V |
6A (DC 4A ) |
12V>20AH |
RCB-8 |
50HZ 220V |
12V |
8A (DC 5.4A ) |
12V>30AH |
|
| |
3 、 Use methods |
| 3.1 The charger must be installed in the well-ventilated and none-acidity corrosive environment. |
| 3.2 The input voltage must be correspondent with the instructions. |
| 3.3 The cable (red and black) must be connected to the battery corresponding. |
| 4 、 The use of the charger indicator light. |
| There are five indicator lights which are used to shown current and the quantity of charge . |
The number of LED |
1 2 3 4 5 |
|
Charged electric current |
0 20 40 60 80 100 |
%*rated current |
The quantity of charge |
100 80 60 40 20 |
%*battery capacity |
|
| |
| 5 、 Caution |
| (1)The electric power must be corresponding with the instructions. |
| (2) Do not reverse. |
| (3) Open the None hermetic battery |
| 6 、 Malfunction guide |
| Phenomenon Reason |
| No current (1) Battery is full |
| (2)Connect failure |
| (3)Bad power source |
| Can't charge fully |
| (1)Time is not enough |
| (2)Charge voltage is too low |
| (3) Battery breakdown |
| |
| 2、SPECIFICATIONS: BC-1230 |
| |
 |
| |
Input .................... 160~265 Volts AC 50Hz, |
| Output ............................ 6-30 Amps DC 12/24 Volts(select automatically) |
| Dimensions.............. 250 × 210 × 7(mm) |
| Weight ................................................. 3.5Kg . |
| Efficency..........................................86% |
| Operate Temperature .......................-10 -40 ℃ |
| Storage Temperature ........................-40 -70 ℃ |
| Charge Voltage.................................. 14.5V/29V |
| Float Charge Voltage ......................... 13.5V/27V |
| 3. The length of time needed for recharging will depend on the size and depth of discharge of the battery. A minimum of one hour is needed and full charging of a large battery may take up to12 hours. |
| 4. For best results, the charger should be allowed to complete its full cycle as indicated by the green "Ready" LED, and if possible, the battery should be left connected and on-charge permanently until it is required for immediate use. There is no need to switch off the charger to prevent over-charging. |
| |
| 3、C-20-12 |
 |
| 1。Switched Mode Design. |
| 2。Fixed voltage Mode(power supply)Function. |
| 3。Remote Control Panel Display. |
| 4。Wide voltage range operation.(90-135 VAC,180-270VAC,50/60Hz) |
| 5。Durable and corrosion resistant chassis. |
| 6。Over-temperature shutdown and overload protection. |
| 7。Transformer isolated for safety. |
| 8。Reverse polarity protection. |
| 9。Short-circuit and surge protection. |
 |
| |
| 4、C-40-12 |
 |
| 1。Switched Mode Design. |
| 2。Fixed voltage Mode(power supply)Function. |
| 3。Remote Control Panel Display. |
| 4。Wide voltage range operation.(90-135 VAC,180-270VAC,50/60Hz) |
| 5。Durable and corrosion resistant chassis. |
| 6。Over-temperature shutdown and overload protection. |
| 7。Transformer isolated for safety. |
| 8。Reverse polarity protection. |
| 9。Short-circuit and surge protection. |
 |
